Epson F6070 Guia de preparacion

Epson® SureColor® F6070 Setup Guide

10 | Setting the Language5. Contact a service engineer to attach the Epson Genuine Ink Supply System, Ink Supply System Cover 2, and to adjust the pri

Loading Roll Paper | 11Loading Roll Paper1. Confirm that the adapter holder lock lever is raised.2. Place the roll paper on top of the printer.3. If n

12 | Loading Roll Paper4. Raise the adapter lock lever to release the lock on each of the two roll paper adapters.5. Press the adapters in until they

Loading Roll Paper | 137.Slide the roll paper all the way to the right. Following the adapter guide, slide the roll slowly back.8. Press the ( button

14 | Loading Roll Paper9. Insert the roll paper in the paper slot and pull it through. Make sure that the paper is free of slack and that the end is n

Installing the Software | 15Installing the SoftwareYou can use USB and/or Ethernet network connections.For USB connection, make sure your system has t

16 | Network Installation3. Follow the on-screen instructions to complete the installation.Network Installation1. Make sure your printer is powered on

Network Installation | 17EPSON and SureColor are registered trademarks, and EPSON Exceed Your Vision is a registered logomark of Seiko Epson Corporati

2 | Unpacking and Assembling the PrinterRead all of these instructions before using your printer. Also be sure to follow all warnings and instructions

Unpacking and Assembling the Printer | 3When choosing a place for the printer, leave adequate room for easy access and ventilation. Avoid locations su

4 | Unpacking and Assembling the PrinterStandThe items below can be found in the “Ink Supply System Cover 2” box.Horizontal strutLegsHex wrenchMountin

Assembling the Stand | 5Assembling the StandUnpack the stand and make sure you have all of these items:.Note: You will also need a hex screwdriver.1.R

6 | Assembling the Stand2. Use the long end of the hex wrench to tighten the pre-placed screws on each side of the horizontal strut.3. Remove the four

Assembling the Stand | 74.Remove the plastic piece as shown.5. Fasten the mounting piece to the bracket using two B screws.6. Slide the mounting piece

8 | Installing the Printer7. Insert the plastic piece and tighten the screws.Installing the PrinterYou need six people to install the printer; four pe

Installing the Printer | 92.Using four people, lift the printer as shown.Caution: When lifting the printer, only hold the highlighted areas, otherwise