Epson TM-U300A Manual del operador

Return to main menuTM-U300A/U300B/U300PA/U300PBOperator’s ManualUsing this online operator’s guideThe words on the left side of this screen are bookma

n Operation panelPanel Switches➀ POWER switchTurn the printer ON and OFF.➁ FEED switchFeeds roll paper.* Feeds roll paper based on the line feed amoun

Chapter 2 Before Setting Up2-1 Connecting the AC Adapter to the Printern Plugging in AC adapterCAUTIONS:* Before connecting the printer to the power s

2-2 Connecting the Host Computer to the Printern Connecting the interface cableConnect the printer with the host ECR (host computer) through an interf

<TM-U300PA/U300PB>Connect the interface cable according to the following procedure.➀ Turn off the printer, and the ECR (host computer).➁ Plug th

Chapter 3 Installing the Parts3-1 Installing the Ribbon Cassetten Installing the ribbon cassetteBe sure to use a ribbon cassette that matches the prin

➂ Fit the ribbon between the head unit and the ribbon mask. Then push thecassette firmly into position.➃ Turn the ribbon-tightening knob five or six t

Exchanging the ribbon cassetteBe sure to use a ribbon cassette that matches the specifications.➀ Open the printer cover.➁ When removing the ribbon c

3-2 Installing the Roll Papern Installing the roll paper for TM-U300A/U300PABe sure to use roll paper that matches the printer’s specifications.➀ Usin

➃ Turn on the printer.➄ While leaving some slack in the roll paper, insert the end of the roll paperstraight into the paper inlet. The printer automat

➇ Install the take-up spool to the take-up frame.➈ Tear off the receipt paper by the cutter whenusing the 2-ply paper and 3-plypaper.➉ Close the print

1 station printerTM-U300A/U300BTM-U300PA/U300PBOperator’s Manual400137504

Installing the roll paper for TM-U300B/U300PBBe sure to use roll paper that matches the printer's specifications.➀ Using scissors, cut the lead

➃ Turn on the printer.➄ While leaving some slack in the roll paper, insert the end of the roll paperstraight into the paper inlet. The printer automa

n Exchanging the paper rollBe sure to use roll paper that matches the printer’s specifications.<TM-U300A/U300PA>➀ Open the printer cover and the

3-3 Adjusting the Paper Near-End Detector The paper near-end detectorThe paper near-end detector senses when the paper is nearing its end and turnso

➃ The adjusting screw which holds the roll paper near-end detector, may beloosened and then set the top of “B” to the adjustment value found in ➂, and

3-4 DIP Switchesn Locating DIP switchesOn the bottom of your printer are DIP switches that allow the printer to be set orperform a number of different

n TM-U300A/U300B DIP Switch FunctionsTable 3-2. TM-U300A/U300B DIP Switch FunctionsSwitch Function ON OFFSW-1 Data receive error Ignored Prints “?”SW-

Chapter 4 The Self Test 4-1 The Self Testn The purpose of the self testThe self test checks whether the printer has any problems. When the printerdo

Chapter 5 Removing Jammed Paper5-1 Removing Jammed Paper Removing jammed paperRemove jammed paper according to the following steps.➀ Open the roll-pa

APPENDIXAPPENDIX A General Specifications1. Printing specificationsPrinting method:Head wire arrangement:Printing directions:Lines per second:Characte

All rights reserved. No part of this publication may be reproduced, stored in a retrievalsystem, or transmitted in any form or by any means, mechanica

Table A-1. Character Size, Characters Per Line, Characters Per Inch(*1) 7 X 9 font is the default. (*2) ANK: Alphanumeric and KanaExample) 7 X 9 font

[Condition]* Character font: 7 X 9 font(with descenders)* Printing pattern: ASCII 96-character rollingpattern continuous printing- Temperature: 25°C4.

Maximum diameter:Ø 83 mm (When 2-ply or 3-ply paper is used.When 1-ply paper is employed, the maximum diam-eter shall be Ø 60 mm.)Paper core inside di

Storage:-10 to 50°C (excluding paper andribbon cassette)Humidity:Operating: 20 to 80°C (non-condensing)Storage:20 to 90%(non-condensing, excluding pap

EMC and Safety Standards Applied PrinterProduct Name: TM-U300A/B, TM-U300PA/PBModel Name: M51JA/B, M51PA/PBThe following standards are applied only t

INTRODUCTIONThe TM-U300A/U300B and TM-U300PA/U300PB printers are designed to provide a highcost-performance ratio. They are compact, light-weight, and

CONTENTSChapter1 UnpackingthePrinter... 11-1 Checking the Contents of the Box.

Chapter 1 Unpacking the Printer1-1 Checking the Contents of the Boxn Checking the partsThe illustration below shows the items included for the standar

1-2 Choosing a Place for the Printern Avoid locations that are subject to direct sunlight or excessive heat (nearheaters).n Avoid using or storing the

1-4 Names and Functions of Partsn Part names➀ TM-U300A/U300PA: Take-up cover ➄ Interface connectorTM-U300B/U300PB: Roll-paper cover ➅ Drawer kick-out