Epson ActionNote 880C Guía de usuario descargar pdf (Pagina 53)

Note

If you are using an ATA hard disk or ATA flash card, make

sure your CONFIG.SYS file contains this command:

DEVICEHIGH=C:\CARDSOFT\ATADRV.EXE

If you are using an SRAM card, make sure the CONFIG.SYS

file contains this command:

DEVICEHIGH=C:\CARDSOFT\MTSRAM.EXE

Both of these drivers are loaded in your computer’s

CONFIG.SYS file at the factory.

The following table describes the removable storage card

utilities.

ATA utility commands

Command

ATAINIT*

ATADRV

MTDDRV

Function

Partitions the ATA card and identifies its physical

parameters: then you can use MS-DOS FORMAT to format

the drive.

Assigns the next available drive letter to the ATA drive.

When you start your system, you see a message identifying

the drive letter assigned to the drives in your PCMCIA slots.

Displays the drive letter for SRAM and ATA cards. Since these

cards share drive letters, it is important to know where these

cards are installed.

This command works only with ATA cards that are supported by the

ATADRV driver.

2-18 Using Your Computer

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 138 139

Sin comentarios

Epson ActionNote 880C Guía de usuario Pagina 53