Epson 1010 Manual de usuario descargar pdf (Pagina 2)

Epson E1007 4x12 LCD Display Connector Pin Out and Start-up Code

www.soc-machines.com

- 2 -

The E1007 display is shown above. The Voltage Volume command is set to 0A on the left and

0F (maximum setting) on the right at 2.8V – note the display washes out at the maximum setting.

The E1010 display below with Voltage Volume set to 00 (minimum) – this display washes out at

2.9V – haven’t found a way to get this display to work at 3 or 3.3V.

The E1010 display is shown above with some of the top row symbols turned on. The E1010

symbol inventory is more extensive than the E1007. The picture on the right shows our TinyLCD

controller driving the E1007 (TinyLCD uses an Atmel ATmega168 processor on the back of the

PCB with the E1007 mounted on the front). The display runs just fine from 2.4 to 3.6V – the

Voltage Volume setting should be adjusted for correct contrast.

The SED1230 symbol activation is controlled via a 64 bit symbol register. By turning various

bits on or off top row symbols can be individually turned on or off. E1010 symbol-register

mapping is described in the ECMA1010 User Guide. The E1007 symbol register mapping is

shown on the next page.

Character pattern is SED1230-Db (see page 6-27). Nice little display.

Mating connector is Omron XF2H-1315-1 Digikey Part No. OR641CT-ND (haven’t tried this

connector yet but should work).

1 2 3 4 5 6 7

Sin comentarios

Epson 1010 Manual de usuario Pagina 2