Epson EPL-N2000 Guía de usuario Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 91
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
5-4 Configuring the EPL-N2000 for UNIX
If the card responds, you are ready to print. If not, print a
status sheet and check the IP address to make sure that it
corresponds to the IP address entered in the /etc/hosts file.
If you used the IP address to test the connection, make sure
that you entered it correctly with ping.
Setting Up the EPL-N2000 as a Remote Printer
After you set up the EPL-N2000 as a network device, you need
to set it up as a remote printer. If your UNIX system has an
/etc/printcap file, continue with the procedure below. If not,
see “Setting Up the EPL-N2000 with Other UNIX Systems”
later in this chapter.
In addition to the host name assigned when you set up the
printer as a network device, you must enter a remote printer
name for the EPL-N2000 and a local printer name for the
printer whose output is being redirected.
Users who want to append a form feed to the end of a print file
or insert carriage returns at the end of lines must include
output filters when they send a print job. Before users can enter
filters with the lpr command, you must set up the EPL-N2000
to recognize these filters. You do this by specifying different
remote printer options when you edit the /etc/printcap file.
You must specify a different remote printer name and local
printer name for each remote printer option that you include—
in essence, treating the EPL-N2000 as if it were more than one
printer.
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 90 91

Comentarios a estos manuales

Sin comentarios