Epson LabelWorks Safety Kit Guía de usuario descargar pdf (Pagina 27)

Solving Problems | 25

Solving Problems

If you have a problem with your LabelWorks,

check the display or the troubleshooting

suggestions below.

Error messages

Insert tape Turn the power off and install a

tape cartridge.

Check battery The batteries may be running out

or installed incorrectly, non-

alkaline batteries are being used

with alkaline batteries, or old and

new batteries are being used

together. Turn the power off and

replace batteries with new ones,

or use the optional AC adapter.

Make sure new batteries are

installed correctly.

Too many lines You have exceeded the maximum

number of lines (2). Press

to

delete the lines indicated.

Seq. num. only 1 Sequence numbers have already

been set. You can only enter one

sequence number per ribbon.

Txt too long-OK? Entered text is too long for the

specified ribbon length. Press

and adjust the ribbon length

or make text shorter.

Overheated! The print head is too hot. Turn the

power off and take out the tape

cartridge. Allow the print head to

cool before trying to print again.

Cover open! If you open the rear cover while

the power is on, this message

displays and the power turns off

automatically. Always turn the

power off before opening the rear

cover.

Delete all text? When creating a ribbon with a

special format, the current text

will be deleted. Press to

delete the text and show the

special format.

Motor error! An error occurred in the motor

operation. Turn the power off,

then turn it back on. If the same

message appears, turn the power

off again and contact Epson for

technical support.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 39 40

Comentarios a estos manuales

Sin comentarios