Epson TM-P60II Manual de usuario

TM-P60II w/ Zebra Emulation Setup Manual - 05/14 1

To configure the LAN parameters, Install EpsonNet Config. Launch the EpsonNet Config Utility, select “Refresh” if the printer does not appear… Highlig

Click “TCP/IP – Basic” and enter the correct LAN parameters. To enable DHCP, select Automatic (Clear - “Set using Automatic Private IP Addressing (

Click “OK” at the “complete message 12

Appendix A – Printer self- test printouts 13

Appendix B - TM-P60 Configuration Utility Detailed Setup Select Manual Configuration Printer Settings Print Density - adjusts the darkness of p

Memory Switch Settings • Zebra Emulation – sets the printer to Zebra or Epson mode. • Zebra Language – selects the applicable Zebra syntax. • ZP

Paper Layout Settings • Label Length - sets the media height when printing upside down. • TOF Offset – adjusts the vertical position of the first

Bluetooth I/F Settings • Bluetooth Device Name – assign a unique name or check “Use Serial Number” • Bluetooth Passkey – assign a unique passkey

Table of Contents Printer configuration requirements...

Printer configuration requirements TM-P60II must have Zebra emulation enabled and “printer class” USB mode selected. The other settings are optional,

6 Select Browse my computer for driver software… 7 Browse to the folder where you unzipped the PrintClass Driver. a. Point to the “Driver fold

8 Click Next… 9 Select “Epson TM-P60IIPeeler ReceiptE4”, and click Next. 5

10 Click Close when the update is complete. 11 After the update is complete, a new printer “EPSON TM-P60IIPeelerReceiptE4” will be listed in the “P

Handheld with Bluetooth - Device name: TM-P60II - Passkey: 0000 If necessary these parameters can be changed with the TM-P60 Configuration Ut

2 Select USB Port (Printer Class) or USB Port (TMUSB i.e. Vendor Class). Click OK… Then click on Connection, and Connect. 3 The Connected mess

5 Click Yes to Switch to Vendor Class. 6 The Printer will Reset / No Message will appear. 9