Epson PowerLite 260D Guía de usuario Pagina 92

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 109
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 91
92 Solving Problems
Solving Password Problems
You have forgotten the password.
Write down the request code that appears in the Password Protect
Release screen and contact Epson. See page 94.
If you turned on the password protect feature before setting the
password and no password was set before, try using the default
password:
0000.
The remote control is not available.
You must have the remote control to enter the password. If necessary,
you can purchase a replacement remote control from Epson. See
page 94 for details.
Solving Problems With the Remote
Control
The projector doesn’t respond to remote control commands.
Make sure you are within 6 m of the projector, and within range
of the projector’s front or back sensor (approximately 30° to the
left or right and 15° above or below).
If a button on the remote control is held for more than
30 seconds, the remote enters sleep mode. Press another button
for normal operation.
The remote control batteries may not be installed correctly or may
be low on power. Replace the batteries as described on page 48.
Dim the room lights and turn off any fluorescent lights. Make
sure the projector is not in direct sunlight. Strong lighting,
especially fluorescent lights, may affect the projector’s infrared
receivers.
Vista de pagina 91
1 2 ... 87 88 89 90 91 92 93 94 95 96 97 ... 108 109

Comentarios a estos manuales

Sin comentarios