
26
LPC23xx Devices
Built for connectivity, these powerful yet cost-effective microcon-
trollers support 10/100 Ethernet, full-speed (12 Mbps) USB 2.0, and
CAN 2.0B. They have up to 512 KB of ISP/IAP Flash, up to 98 KB of
SRAM, 10-bit A/D and D/A converters, an IRC oscillator, and options
for an SD memory-card interface.
KEY FEATURES
u
72-MHz, 32-bit ARM7TDMI-S with dual AHB buses
u
Up to 512 KB of ISP/IAP Flash
u
Up to 98 KB of SRAM
u
Very fast Flash programming via on-chip boot loader
u
10/100 Ethernet MAC interface with DMA
u
USB 2.0 full-speed (12 Mbps) device with PHY and DMA
u
USB 2.0 full-speed Open Host Control Interface / On-The-Go
(LPC2388 only)
u
Two CAN 2.0B controllers with acceptance filtering
u
General-purpose DMA controller 4 10-bit A/D converter
and 10-bit D/A converter
u
Multiple serial interfaces: three I
2
C, one I
2
S, four UARTs,
and three SPI/SSPs
u
Four 32-bit timers
u
Real-time clock and Watchdog timer
u
4-MHz internal RC (IRC) oscillator trimmed to 1% accuracy
u
Secure Digital (SD) memory-card interface
(LPC2368/77/78/87/88 only)
u
Single 3.3-V power supply (3.0 to 3.6 V)
u
Several power-down modes, including “deep-power-down”
u
Boundary scan (LPC2377/78/88 only)
u
Packages:
– LQFP100 (14 x 14 x 1.4 mm)
– LQFP144 (20 x 20 x 1.4 mm)
– TFBGA100 (9 x 9 x 0.7 mm)
ARM7-based microcontrollers
with Ethernet, USB, and
CAN peripherals
LPC23xx block diagram
Up to 512 KB of
128-bit-wide ISP/IAP Flash
E-ICE/RT interface and
embedded-trace macrocell
Up to 98 KB of total SRAM
Enhanced vectored
interrupt controller
72-MHz, 32-bit ARM7TDMI-S
core with dual AHB buses
Power management, 3.3-V supply, real-time clock,
Watchdog timer, internal RC, PLL
10/100 Ethernet MAC
with 16 KB of SRAM
Two CAN buses
with acceptance filters
USB 2.0 full-speed device, OHCI/OTG
with PHY, DMA, and 4 KB FIFO
General-purpose
DMA controller
10-bit A/D converter
(up to eight channels)
10-bit D/A converter
(one channel)
Four 32-bit timers
(with capture/compare channels)
PWM unit
Four UARTs
(UART1 with modem control)
SD/MMC memory-card interface
(LPC2368 and LPC2378 only)
I
2
S Three I
2
C
One SPI and two SSP
Real-time clock with
2-KB battery-backed RAM
70 I/O pins
104 I/O pins (LPC2377/78/88)
Comentarios a estos manuales