Epson PowerLite 5000 Manual de servicio Pagina 68
- Pagina / 127
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
EPSON PowerLite 5000 Service Manual
3-2
These units are specified as the optical engine. (Treat as one replaceable part in field
maintenance.)
À
Optical head unit
Á
Prism unit
Â
Light guide unit
Ã
Projector lens unit
Ä
Driver board
Note: Do not disassemble the optical engine or replace any unit in the optical engine.
3.1.4 Mechanical Adjustments
Optical Head Unit
The polarization plates (R/G/B) are factory-aligned. Do not apply any mechanical
stress to the polarization plate, and do not loosen the screws. If the alignment is
modified, color divergence will occur, and the color images will not be clear.
Prism Unit
To synthesize the light output from each polarization plate (including R/G/B light
valves), the prism unit (concurrent with the polarization plate) is aligned in the factory.
If the alignment is modified, pixel divergence in R/G/B synthesizing and in the projector
lens unit causes out-of-focus images and non-uniform color.
Caution: Do not loosen the prism unit mounting screws.
Light Guide Unit
The components of the light guide unit are factory-aligned. If the alignment is modified,
clear images cannot be produced, because the brightness or chroma is not uniform on
the screen.
The lens array and mirrors are aligned in the factory to support the best display
performance of the light guide unit. If the alignment is modified or the location is
changed, the display screen may be distorted.
Caution: Do not disassemble the light guide unit. If you remove the upper guide
cover from the unit, the alignment of lenses or mirrors may be changed or
dust may stick to the unit. Since the projector requires precise adjustment, it
cannot be adjusted in the field.
- Service Manual 1
- PowerLite 5000 2
- VCCI COMPLIANCE STATEMENT 3
- REVISIONS 3
- COPYRIGHT INFORMATION 3
- TRADEMARK INFORMATION 3
- INTRODUCTION 4
- PRECAUTIONS 5
- Contents 7
- CHAPTER 4 TROUBLESHOOTING 9
- APPENDIX A 9
- 1.1 PRODUCT FEATURES 10
- 1.2 PARTS OF THE PROJECTOR 11
- Figure 1-3 12
- Figure 1-4 12
- Figure 1-5 13
- Figure 1-6 13
- Figure 1-8 14
- Figure 1-9 15
- 1.3 CONNECTIONS 16
- Power Book 18
- Table 1-1 18
- Video Devices 19
- Audio Devices 19
- 1.4 MAIN COMPONENTS 20
- FR board 21
- CN board 21
- Receptor boards 21
- Speakers 22
- Inlet unit 22
- Filter unit 22
- Power supply unit 23
- Lamp inner housing 23
- Control panel 23
- Optical engine 24
- Top side view 24
- Bottom side view 24
- 1.5 SPECIFICATIONS 25
- POWER SUPPLY 26
- 1.6 INTERFACE SPECIFICATIONS 27
- 1.6.5 S-Video 28
- 1.6.6 Video-In 29
- 1.6.7 Audio In L/R 29
- 1.6.8 Mouse / Com 1/2 30
- 2.1 HARDWARE 31
- Figure 2-2 33
- FC board 34
- Figure 2-3 34
- Figure 2-4 35
- 2.2 POWER SUPPLY UNIT 36
- Functional Outline 37
- Figure 2-7 38
- 2.3 MAIN BOARD 39
- • Lamp power 40
- • Backup Power 40
- 2.4 DRIVER BOARD 42
- Figure 2-11 44
- 2.5 CONTROL PANEL 45
- 2.6 AU BOARD 46
- 2.7 FR BOARD 48
- Figure 2-16 49
- 2.8 CN BOARD 50
- Figure 2-19 51
- Figure 2-20 51
- Figure 2-21 52
- 2.10 SPEAKER UNIT 53
- 2.11 LIGHT GUIDE BLOCK 54
- • Lens Arrays A and B 55
- 2.12 LAMP INNER HOUSING 56
- Light source lamp 57
- Fuse board (FU board) 58
- 2.13 SENSORS/SWITCHES 59
- 2.13.1 Filter Cover Switch 60
- 2.13.2 Interlock Switch 61
- 2.13.3 Safety Switch 61
- 2.13.5 LV Thermistor 62
- 2.13.4 Lamp Thermistor 62
- 2.13.6 PBS Thermistor 63
- 2.14 BOARD CONNECTIONS 64
- Figure 2-37 65
- Figure 2-38 65
- AC InIet 66
- Power Supply Connector 66
- Connector Board 66
- 3.1.1 Preparatory Procedures 67
- 3.1.4 Mechanical Adjustments 68
- Driver Board 69
- 3.1.6 Precautions 70
- Figure 3-1 71
- Figure 3-2 72
- Figure 3-3 72
- Figure 3-4 73
- Figure 3-5 74
- Figure 3-6 74
- Figure 3-7 75
- Figure 3-8 75
- Figure 3-9 76
- Figure 3-10 76
- Figure 3-11 77
- Figure 3-12 77
- Figure 3-13 78
- Figure 3-14 78
- Caution: 79
- 3.2.8 Removing the Main Board 80
- Figure 3-18 81
- 3.2.9 Removing the AU Board 82
- Figure 3-20 83
- Figure 3-21 84
- 3.2.11 Removing the FR Board 85
- Figure 3-24 86
- Figure 3-25 86
- Figure 3-26 87
- Figure 3-27 88
- Figure 3-28 88
- Figure 3-29 89
- Figure 3-30 90
- Figure 3-31 90
- Figure 3-32 91
- Figure 3-33 92
- Figure 3-34 92
- 3.2.20 Removing the CN Board 93
- Figure 3-37 94
- 3.2.22 Removing the FC Board 95
- Figure 4-1 97
- Figure 4-2 98
- Figure 4-3 99
- Power ON/OFF 100
- Continued from page 4-5 101
- Go to start 101
- Display/Picture 102
- Figure 4-7 103
- Audio Output 104
- Control Panel 105
- Remote Control 106
- Mouse/COM 107
- Figure 4-12 108
- A.1 Parts List 109
- A.2 Exploded Diagrams 112
- Figure A-2 113
- Figure A-3 114
- Figure A-4 115
- Figure A-5 116
- Figure A-6 117
- Figure A-7 118
- Figure A-8 119
- Figure A-10 120
- Figure A-11 121
- Figure A-12 122
- Figure A-13 123
- Figure A-14 124
- Figure A-15 126
- Figure A-16 127
Relacionado con productos y manuales para Cámaras Bridge Epson PowerLite 5000
Cámaras Bridge Epson PhotoPC700 Guía de usuario
(57 paginas)
(57 paginas)
Cámaras Bridge Epson PhotoPC 750Z Especificaciones
(10 paginas)
(10 paginas)
Cámaras Bridge Epson PhotoPC Guía de usuario
(140 paginas)
(140 paginas)
Cámaras Bridge Epson PhotoPC 550 Especificaciones
(12 paginas)
(12 paginas)
Cámaras Bridge Epson PhotoPC L-400 Manual de usuario
(65 paginas)
Cámaras Bridge Epson PhotoPC 800 Especificaciones
(14 paginas)
(14 paginas)
Cámaras Bridge Epson Digitial Camera Guía de usuario
(81 paginas)
(81 paginas)
Cámaras Bridge Epson A882401 Especificaciones
(8 paginas)
(8 paginas)
Cámaras Bridge Epson ELPD04 Manual de usuario
(2 paginas)
(2 paginas)
Cámaras Bridge Epson PhotoPC 3000Z Guía de usuario
(224 paginas)
(224 paginas)
Cámaras Bridge Epson A882401 Información técnica
(144 paginas)
(144 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 1.086 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales