Epson EasyMP Multi PC Projection Guía de usuario Pagina 172

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 201
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 171
Attention
Do not rub the obstacle sensor with harsh materials or subject the sensor to
shocks.
Damage on the surface of the sensor may cause malfunctions.
Cleaning the Air Filter
Clean the air filter and the air intake vent when the following message is
displayed.
"The projector is overheating. Make sure nothing is blocking the air vent,
and clean or replace the air filter."
Attention
Dust collecting on the air filter may cause the internal temperature of the
projector to rise, leading to a malfunction or early deterioration of optical
parts. Clean the air filter immediately when the message is displayed.
Do not rinse the air filter in water. Do not use detergents or solvents.
When using a brush for cleaning, use one with long soft bristles, and brush it
lightly. If it is brushed too strongly, dust will be ground into the air filter and
cannot be removed.
a
After you turn off the projector's power and the confirmation
buzzer beeps twice, disconnect the power cord.
b
Open the air filter cover.
Press the tabs on the air filter cover and open the cover.
Cleaning
172
Vista de pagina 171
1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 200 201

Comentarios a estos manuales

Sin comentarios