Epson EMP-TW20 Guía de usuario descargar pdf (Pagina 17)

Turning the Power on and Projecting Images

Basic Operations

Turning the power off

Selecting the image source

When the projector has cooled down

(takes about 20 seconds) and the

"beep beep" tone sounds, disconnect

the power cable.

If there is a problem with projection even though the projector is set up

and connected correctly, refer to p.34.

TIP

Simply turning off the power does not stop

electricity consumption.

Selecting the image source

If more than one signal source has been connected, or if no images are projected, use the remote

control or the projector's control panel buttons to select the signal source.

Using the remote control

Using the control panel

Press the button that has the name of the port on it

that the desired signal source is connected to.

When you press , the selection menu is displayed.

Use or to select the signal source.

Press to accept.

Selection menu

Selection

If "InputA" is selected, the selection menu will

be displayed.

Turning the power off

Turn the power off for the signal

sources that are connected to the

projector.

Remote Control

Control Panel

Attach the lens cover.

Disconnect the cables that are connecting

other equipment to the projector.

Press .

Pressing will display the following

message, so press once more.

When connecting equipment to the [InputA] port, you may need to switch the image signal to match the

equipment.

< Remote control >

< Control panel >

While projecting an image from equipment

connected to the [InputA] port(s), press

to display the selection menu.

Use or to select the correct signal to match the

equipment.

Press or to accept.

When [Input A] port is connected

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 55 56

Comentarios a estos manuales

Sin comentarios

Epson EMP-TW20 Guía de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Proyectores de datos Epson EMP-TW20