Epson PowerLite X10+ Guía de usuario descargar pdf (Pagina 101)

Solving Problems 101

■ If you’re projecting from a computer, press the Auto button on

the remote control to reset the projector’s Tracking, Sync, and

Position settings.

The image is blurry.

■ There may be dirt or smears on the lens. Clean the lens as

described on page 84.

■ Adjust the focus using the focus ring (see page 52).

■ If the projector is angled sharply toward the screen, it may not be

possible to focus the entire image. Move the projector to position

it more directly in front of the screen.

■ Lower the projection angle to reduce the amount of keystone

correction required.

■ Make sure the projector is within the proper range (projection

distance) from the screen (see page 23).

■ Make sure the lens is not fogged by condensation. You may need

to wait before using the projector after moving it from a cold

environment to a warm environment.

■ If you’re projecting from a computer, you may need to adjust the

tracking and sync settings as described in the next section.

You see vertical bands or the image still looks blurry after

trying the solutions in the previous section.

■ If you’re projecting from a computer and displaying an image that

contains a lot of fine detail, you may notice vertical bands or some

of the characters may look heavy or blurred. Press the

Auto

button on the remote control or the

Enter button on the

projector to reset the projector’s Tracking, Sync, and Position

settings.

note

You must be projecting an

image for the

Auto button

to have any effect. It works

only with computer images

projected through the

Computer (Component

Video) port.

1 2 ... 96 97 98 99 100 101 102 103 104 105 106 ... 128 129

Sin comentarios

Epson PowerLite X10+ Guía de usuario Pagina 101