Epson C I - 4 5 Manual de instrucciones descargar pdf (Pagina 44)

Operator Panel Messages

After switching the power ON the printer runs a self test. During the test the

following messages may be shown on the display:

Display That means ... Cause / Action

No No power - Mains cable not connected

information, or - PSU defective

POWER ON Line voltage set to - Correct the line voltage switch

indicator not 240V not to 115V

lit.

green and hang up in reset after CI - 4040

yellow LED power on - Print CU-DEV defective

give light but CI - 4050

no reaction - PSU defective

- Control Unit defective

######## Firmware does not - PM not inserted

work - PM not correctly inserted

- no firmware on PM

- PROMs not correctly installed

TEST.... Initializing of the - After first POWER ON

(flashing) EEPROM with PM

- Change of the PM

- Contents of the EEPROM

faulty

I/O OK EEPROM located on EEPROM

the Control Unit not - not installed

addressable - not correctly installed

- defective

NV RAM OK Error on the RAM of - Control Unit defective

the Control Unit

RAM OK Checksum error - (P)ROM defective

EPROM 1

ROM 1 OK No Fonts available - Character generator EPROM

on PM damaged or missing

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 93 94

Sin comentarios

Epson C I - 4 5 Manual de instrucciones Pagina 44