Epson Multi-mode Data Controller MFJ-1278B Manual de usuario Pagina 229

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 406
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 228
MFJ-1278B MULTI-MODE OPERATIONAL COMMANDS
ID Mode: Packet Immediate Command
ID is an immediate command. It will send a special identification packet. ID can be used to
force a final identification packet to be sent as a digipeater station is being taken off the air.
The identification packet will be sent only if the digipeater has transmitted since the last
automatic identification.
An identification consists of an unsequenced I frame whose data field is your station
identification. The identification packet is addressed to the "CQ" address set by the
UNPROTO command. Your station identification is your callsign as set by MYCALL, with
"/R" appended.
Id Mode: Pactor Immediate Command
The ID command is an immediate command that when used will invoke an immediate CWID
to be sent. The ID will be sent at 20 WPM and will consist of the station callsign.
IDTime nnn Mode: Pactor Default: 590
Parameters:
nnn: 6<=nnn<=255
The IDTime parameter specifies the time interval between automatically generated CWID
events. The actual time yielded is equal to IDTIME * 10 seconds. The IDTime parameter
is relevant only when bit 0 of the CWIDMODE parameter is set to 0. The default IDTime is
590 seconds.
K (Converse) Mode: Pactor Immediate Command
This command will put the MFJ-1278B into CONVERSE mode from the p_cmd:.
Vista de pagina 228
1 2 ... 224 225 226 227 228 229 230 231 232 233 234 ... 405 406

Comentarios a estos manuales

Sin comentarios