Epson Apex+ Manual de usuario descargar pdf (Pagina 73)

Using the DISKCOPY command

The DISKCOPY command lets you copy all the files on a

diskette to another diskette. Epson also provides a disk utility

called DU to copy diskettes; this utility is described in your

MS-DOS reference manual.

The procedure for copying diskettes depends on whether you

are using an Apex Plus or an Apex Plus 20. Follow the appro-

priate procedure for the computer you are using.

NOTE

If you are using an Apex Plus 20, be aware that you cannot use

DISKCOPY to copy files from a hard disk to a diskette.

DISKCOPY only copies files between diskettes. To copy a file

from a hard disk to a diskette, use either the COPY command

or the BACKUP command. See the appropriate section in this

chanter or your MS-DOS reference manual for instructions.

Using DISKCOPY with an Apex Plus

When you use the DISKCOPY command, you need to specify

the disk drive (A: and B:). If you do not, MS-DOS copies the

diskette in drive A to a second diskette that you insert in drive

A. This means you must swap diskettes during the copy process.

MS-DOS displays prompts to tell you when you need to change

diskettes.

Make sure your original diskette is write-protected. (See

Chapter 2 for instructions.)

Insert your working copy of the MS-DOS system diskette

in the top drive (drive A).

3-16 Using MS-DOS with Your Apex

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 157 158

Sin comentarios

Epson Apex+ Manual de usuario Pagina 73