Epson CMD-2260 (CD-ROM) Información técnica descargar pdf (Pagina 206)

Blastware Advanced Module

____________________________________________________

6–16 Blastware Operator Manual

NOTE: The units are set to Pa if the Report Options are Metric, or psi if the Report Options are

set to Imperial.

1. Select the Normal (+/- 100Pa) or Sensitive (+/- 25 Pa) range on Channel 1 and/or 4.

NOTE: Make sure the proper range is selected as the unit cannot dynamically change this while it is

monitoring. After selecting the range the sensitivity will automatically be filled in.

2. Select Trigger Level. Enable or disable any channel including the sound channel as a trigger

source. Assuming it is set as a trigger source the Trigger Level is the level at which the unit

would trigger and start recording data.

Selecting the Trigger Level menu will also allow you to change the recording range between

Sensitive and Normal on the monitor.

3. Edit the values, as required, for the Record Mode, Sample Rate and Record Time. To ensure

the best possible reproduction of the recorded event, a 65536 sps is recommended. Lower

sample rates will trade off between the resolutions and longer record times.

4. If only Channel 1 is to be monitored, turning off all other channels will also allow for longer

recording times.

5. Send the Setup File to the unit.

1 2 ... 201 202 203 204 205 206 207 208 209 210 211 ... 223 224

Sin comentarios

Epson CMD-2260 (CD-ROM) Información técnica Pagina 206