Epson CMD-2260 (CD-ROM) Información técnica descargar pdf (Pagina 208)

Blastware Advanced Module

____________________________________________________

6–18 Blastware Operator Manual

i Select

Choose the channels to be used during flex operations. Click on the checkbox to display a

checkmark to enable the channel. Channels must be enabled or disabled according to the following

restrictions; Channel 1 only, Channels 1 and 2, Channels 1 through 4, or Channels 1 through 8

(eight channel monitor required). The flex feature requires that the channels be selected in a

sequential order; for example, you are not able to select channels 1-4, and then 6-8.

ii Name (5 char max)

Enter a name to refer to the channel name. The name can be a maximum of five characters long.

iii Units (6 char max)

Enter a name to refer to the measurement units for each channel. A summary table of the Instantel

sensor units is available in Section 5.3, Advanced Setup. Refer to the manufacturers specifications

for non-Instantel sensors.

iv Sensitivity (Volts/Unit)

A summary table of the Instantel sensor units is available in Section 5.3, Advanced Setup. Refer

to the manufacturer’s specifications for non Instantel sensors.

v Gain

Choose the required range and resolution. Click on either button.

vi +/– Trigger

Enter a trigger level if using single shot or continuous record modes.

vii Level

Enter the trigger level.

viii Enable

These checkboxes enable the trigger on a particular channel. You can enable the triggers on

any combination of channels. Recording begins when Event activity exceeds any single set

trigger level.

ix +/– Resolution

The Blastware software automatically calculates the resolution based on the entered sensitivity and

chosen gain.

x +/– Range

The Blastware software automatically calculates the range based on the entered sensitivity and

chosen gain. Refer to this value when setting a trigger level.

(3) Instrument

i Record Mode

Choose single shot, continuous, manual record mode, histogram, or histogram combo.

Advanced histograms calculate only the peak particle velocity for each interval. Dependent on

which Record Mode you select, subtle changes will occur in the Instrument area of the dialog

box. See below for a description of these changes:

1 2 ... 203 204 205 206 207 208 209 210 211 212 213 ... 223 224

Sin comentarios

Epson CMD-2260 (CD-ROM) Información técnica Pagina 208