Epson Stylus Color 3000 Guía de usuario Pagina 124

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 123
Troubleshooting
6-16
Paper jams inside the printer.
Paper doesn’t eject fully or is wrinkled.
Try this Then do this
Turn off your printer, open
the cover, remove any
loaded paper, and remove
any little pieces that may
have torn off inside.
You may need to turn the knob on the left side of the printer
counterclockwise to eject all the torn pieces of paper. Never turn
this knob when the printer is on. You’ll lose the top-of-form
position and may damage the printer. If you were printing labels,
make sure there are no labels or adhesive stuck inside.
Then reload the paper as described in Chapter 3.
If your paper jams frequently, make sure you:
Use smooth, high-quality paper, with the printable side loaded
correctly for your media type and feeder.
Fan the stack and then even the edges before loading it.
Don’t load too much paper for your media type and feeder.
Adjust the edge guides or sprockets to fit the width of your
paper snugly, but without too much slack.
Possible cause Solution
If the paper doesn’t eject
fully, you may have set the
wrong paper size.
Press the Load/Eject button to eject the paper. Then make sure
you select the correct paper size in your application software,
printer software, or default-setting mode. (See the paper
specifications in Appendix B for the paper sizes you can print with.)
If it’s wrinkled when it
comes out, the paper may
be damp or too thin.
See the paper specifications in Appendix B for paper thicknesses
you can print with, as well as environmental requirements for
storage.
Loire-PLUS.BK.book Page 16 Friday, May 2, 2003 2:56 PM
Vista de pagina 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 151 152

Comentarios a estos manuales

Sin comentarios