Epson ActionPC 2000 Guía de usuario Pagina 47

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 129
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 46
Changing the Jumper Settings
The jumpers on the main system board control certain
functions and are preset at the factory to default positions;
however, you can use the information in the following tables to
change their settings, if necessary.
Jumpersettings
Jumper Jumper
number
setting Function
J3
1-2
Enables VGA IRQ
OFF*
Disables VGA IRQ
J6
1-2 *
Enables COM1
2-3
Disables COM1
J7
1-2*
Assigns COM1 serial port as COM1 (3F8H-3FFH)**
2-3
Assigns COM1 serial port as COM3 (3E8H-3EFH)**
J8
1-2 *
Enables COM2
2-3
Disables COM2
J9
1-2*
Assigns COM2 serial port as COM2 (2F8H-2FFH)**
2-3
Assigns COM2 seriaI port as COM4 (2E8H-2EFH)**
J10 1-2 *
Enables parallel port
2-3
Disablesparallel port
J11
1-2*
Assigns parallel port as LPT1 (378H-37FH)**
2-3
Assigns parallel port as LPT2 (278H-27FH)**
J12 1-2
Enablesgame port
2-3*
Disablesgame port
J13 1-2 *
Enables diskette drive controller
2-3
Disables diskette drive controller
J14 1-2 *
Enables the IDE hard disk drive controller
2-3
Disablesthe IDE hard disk drive controller
J15 1-4
Selectsexternal battery
2-3 *
Selects the system board battery
3-4 Discharges CMOS memory (this resets the SETUP
values to their factory defaults)
3-6
Installing and Removing Options
Vista de pagina 46
1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 128 129

Comentarios a estos manuales

Sin comentarios