Epson ActionPC 2000 Guía de usuario descargar pdf (Pagina 72)

Connecting the ribbon and power cables to the drive

Follow the steps below to connect the hard disk drive ribbon

cable and a power supply cable to the drive:

Locate the hard disk drive connector on the end of the hard

disk drive ribbon cable.

Locate pin 1 on the drive connector. If you do not see it on

the connector casing and you did not locate it before you

replaced the drive bracket, you may have to remove the

drive and turn it over to check the circuit board. See page

4-14 for instructions on removing the drive and page 4-6 for

instructions on locating pin 1 on the drive connector.

Position the connector on the cable so that the red wire

aligns with pin 1 on the drive.

Make sure the holes in the cable connector fit over all the

pins; then push in the connector.

Installing and Removing Drives

4-11

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 128 129

Sin comentarios

Epson ActionPC 2000 Guía de usuario Pagina 72