Epson Stylus Color II Ink Jet Printer Guía para resolver problemas descargar pdf (Pagina 6)

First remove the transportation screw securing the print head

to the carriage. Flip down the output tray and lift up the

printer cover. Loosen the transportation screw by turning its

handle counterclockwise; then lift it off the carriage. Save the

screw so you can reinstall it if you transport your printer

later.

Follow the directions on the Notice Sheet (packed with the

printer) to remove the rest of the protective materials.

Installing the Ink Cartridges

Follow the steps in this section to install your printer’s ink

cartridges.

Warning:

The ink cartridges are self-contained units. Under ordinary

use, ink will not leak from a cartridge. If ink gets on your

hands, wash them thoroughly with soap and water. If ink gets

into your eyes, flush them immediately with water.

Caution:

Do not open the ink cartridge packages until just before you

install them or they may become too dry.

1. Make sure the printer is turned on.

2. Lower the output tray at the front of the printer. Then lift

up the printer cover using the notches at both sides.

3. Hold down the

Alt

button for about five seconds until the

print head moves slightly to the left, the ink cartridge

install position. The

Pause

light begins flashing.

Caution:

Never move the print head by hand; always use the

Alt

button to move it.

4. Pull up each of the ink cartridge clamps to open them.

5. Remove the protective sheet from the color cartridge holder.

6. Open the foil ink cartridge packages and take out the

cartridges. Remove the tape seal from the top of each one.

Caution:

You must remove the tape seal from the top of the

cartridges; leaving the tape on will permanently damage

them. Do not remove the tape seal from the bottom of the

cartridge; ink will leak out.

7. The color cartridge, which is larger, goes on the right.

Install the black ink cartridge on the left. Lower the

cartridges into their holders with the labels facing up and

the arrow on the top pointing toward the back of the

printer.

Be sure to install both ink cartridges. The printer will not

work if only one cartridge is installed.

protective sheet

EPSON Stylus COLOR II

EPSON Stylus COLOR II-6 8/1/95 Ink Jet Printers

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Epson Stylus Color II Ink Jet Printer Guía para resolver problemas Pagina 6

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Epson Stylus Color II Ink Jet Printer