Epson Stylus Color II Ink Jet Printer Guía para resolver problemas descargar pdf (Pagina 7)

8. Push down the ink cartridge clamps until they lock in place.

Caution:

Once you install the ink cartridges, do not open the clamps

or remove the cartridges except to replace them with new

ones. Once you remove a cartridge, do not reuse it.

Reusing a cartridge that has been removed may damage the

print head.

9. Press the

Alt

button again to return the print head to its

home position. (Even if you do not press

Alt

, the print

head moves back to its home position about 30 seconds

after you close the clamps.)

After you install the ink cartridges, the printer charges the

ink delivery system. This takes about two minutes.

During this time, the

Pause

light flashes. When the

printer is finished charging, the

Pause

light stays on

without flashing.

Caution:

Never turn off the printer when the

Pause

light flashes.

10.Close the printer cover.

In order to maintain optimum print quality, the printer

periodically performs a cleaning operation. You may notice

the cleaning cycle being performed when the printer has

been on for awhile without being used or when you turn it

on after it has been off for awhile.

Loading Paper

You can load up to 100 sheets of plain paper. For paper

specifications, see “Printer Specifications.”

Always load plain paper with the printable surface facing up.

The printable surface is marked with an arrow on most plain

paper packaging.

1. Slide the left edge guide on the sheet feeder to the left as

far as it will go.

2. Fan a stack of paper; then tap it on a flat surface to even the

edges.

3. Load the stack of paper, printable side up, so that its right

edge is firmly against the right side of the sheet feeder.

Then slide the left edge guide against the left edge of the

paper. Do not load paper above the arrow printed on the

inside of the left edge guide on the sheet feeder.

Testing the Printer

Before continuing, test the printer to ensure it is functioning

properly. For the self test, use paper that is at least 8.25

inches (210 mm) wide.

1. Press the

POWER

switch to turn off the printer.

2. While holding down the

Load/Eject

button, press the

POWER

switch to turn on the printer.

The 360 dpi self test begins by printing in black ink on the

first and last lines of the first sheet of paper to measure the

page length. Then it prints character samples on the next

sheet using the available fonts and colors.

3. To end the self test, press the

Pause

button and then turn

off the printer. Otherwise, the test continues until the

paper in the sheet feeder runs out.

Caution:

Do not turn off the printer before pressing the

Pause

button.

If the quality of the test output is not good, clean the print

heads as described in “Printer Care.” (It may take as many as

five cleaning cycles to fully solve the problem.)

Calibrating the Printer

Your printer has been calibrated at the factory so that vertical

lines in your text and graphics are properly aligned. If you

notice misaligned images in printouts, however, you can

calibrate the printer with the Bi-D Calibration Utility. You

may need to do this after moving the printer to a new

location, for example.

EPSON Stylus COLOR II

Ink Jet Printers 8/1/95 EPSON Stylus COLOR II-7

1 2 3 4 5 6 7 8 9 10 11 12

Comentarios a estos manuales

Sin comentarios

Epson Stylus Color II Ink Jet Printer Guía para resolver problemas Pagina 7

Comentarios a estos manuales

Relacionado con productos y manuales para Impresión y escaneo Epson Stylus Color II Ink Jet Printer