
EPSON EPL-N1600 Chapter 3 Troubleshooting
Rev. A 96
3.13 DAMAGED PRINTING
Problem Suspect Components
The printed paper is either
wrinkled, creased, or torn.
The followin
components are assosiated with
this specific problem. One or more of these
components ma
have failed partiall
or
completel
. If
ou can not isolate the problem
usin
this procedure, replace each components
listed below, one at a time, until the problem
disappears.
• Fuser Ass
.
• Paper Cassette
• Paper Path Rolls
Step Action and Question Yes No
1
PAPER FEED
• Are the paper cassettes installed
correctl
?
• Is the paper loaded into the
cassette correctl
?
Go to Step 2. Reload the
paper and re-
install the paper
cassette.
2
PAPER CONDITION
Is the paper damp?
Replace with
new, dr
paper.
Go to Step 3.
3
PAPER PATH
Inspect the entire paper path for an
ostructoion or contamination.
Is the paper path free of obstruction
or contamination?
Go to Step 4. Clean or
remove the
obstruction in
the paper path.
4
PAPER PATH ROLLS
Inspect all rolls alon
the paper path
for an
contamination, wear or
dama
e.
Are the paper path rolls free of
contamination, wear or dama
e?
Go to Step 5. Replace the
dama
ed or
worn rolls to
new one.
5
FUSER ASSY.
1. Remove the Fuser Ass
.
2. Inspect the surface of Roll Fuser
and Roll Press.
Are the surface of rolls free of dirt or
scracthes?
Go to Step 6. Clean or
replace the
rolls.
6
IMAGING CARTRIDGE
Install a new Ima
in
Cartrid
e.
Is the print ima
e normal?
Go to suspect
component.
Problem
solved.
Comentarios a estos manuales