Epson TM-T88II Series Manual de instrucciones Pagina 32

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 154
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 31
1-20 Features and General Specifications Rev. A
(*1)(*2)With the RS-485 serial interface specification (a dealer option), DIP Switches 2-7 and 2-8
are disabled.
Notes:
Changes in DIP switch settings (excluding switches 2-7 and 2-8 interface reset signals) are
recognized only when the printer power is turned on or when the printer is reset by using the
interface. If the DIP switch setting is changed after the printer power is turned on, the change
does not take effect until the printer is turned on again or is reset.
If you turn on DIP switch 2-7 or 2-8 while the printer power is turned on, the printer may be
reset, depending on the signal state. DIP switches should not be changed while the printer
power is on.
If the print density is set to level 3 or 4, printing speed is inclined to be low speed.
Transmission speed
Transmission Speed (BPS) SW 1-7 SW 1-8
2400 ON ON
4800 OFF ON
9600 ON OFF
19200 OFF OFF
BPS: Bits Per Second
DIP switch 2
SW 2 Function ON OFF
1 Handshaking (BUSY condition) Receive buffer full
Off line or receive
buffer full
2 Reserved (do not change settings) Fixed to OFF
3
Selects print density Refer to Print Density Selection Table
4
5 Reserved (do not change settings) Fixed to OFF
6 Reserved (do not change settings) Fixed to Off
7 I/F pin 6 reset signal (*1) Enabled Disabled
8 I/F pin 25 reset signal (*2) Enabled Disabled
Print density selection
Print Density SW 2-3 SW 2-4
1 (Light) ON ON
2OFFOFF
3ONOFF
4 (Dark) OFF ON
Vista de pagina 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 153 154

Comentarios a estos manuales

Sin comentarios