Epson TM-T88II Series Manual de instrucciones descargar pdf (Pagina 33)

Rev. A Features and General Specifications 1-21

TM-T88 Series Technical Manual

For parallel interface model

DIP switch 1

DIP switch 2

Notes:

❏ Changes in DIP switch setting (excluding 2-8, interface reset signal) are recognized only when the

printer power is turned on or when the printer is reset by using the interface. If the DIP switch

setting is changed after the printer power is turned on, the change does not take effect until the

printer is turned on again or is reset.

❏ If you turn on DIP switch 2-8 while the printer power is turned on, the printer may be reset,

depending on the signal state. DIP switches should not be changed while the printer power is on.

❏ If the print density is set to level 3 or 4, printing speed is inclined to be low speed.

DIP Switch Function ON OFF

1 Auto line feed Always enabled Always disabled

2 Receive buffer capacity Data buffer 45 bytes Data buffer 4kB

3-8 Not defined — —

DIP Switch Function ON OFF

1 Handshaking (BUSY condition)

• Receive buffer full

• Data reading

• Off-line

• Receive buffer full

• Data reading

Reserved (do not change the

setting)

Fixed to OFF

3 Selects print density Refer to print density selection table

5-7

Reserved (do not change the

setting)

Fixed to OFF

I/F pin 31 reset signal (do not

change the setting)

Fixed to ON

Print density selection

Print Density SW 2-3 SW 2-4

1 (Light) ON ON

2OFFOFF

3ONOFF

4 (Dark) OFF ON

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 153 154

Sin comentarios

Epson TM-T88II Series Manual de instrucciones Pagina 33